Well with submersible pump (submersible pump) under general wells installed in two ways: one is the head is very low (generally less than 30m) of the submersible pump can be installed using the hose; and high lift (generally above 30m) the submersible pump should be used in pipe installation.
1, the use of hose under the installation
The submersible electric pump which is installed under the well of the soft pipe can be directly used for hoisting the rope (such as nylon rope, etc.) which can bear the full weight of the water in the submersible electric pump and the water pipe and the water pipe and the water pipe and the water pipe.
2, the use of steel pipe under the installation
The installation of the steel pipe under the well with submersible electric pump, the installation method as shown in fig..
1) with clamp wells with submersible pump part of the Swiss, and the chain hoist, slowly, well, until the clamps our resting on the wellhead, remove the chain.
2) with another pay clamp of a connecting pipe, flange connecting pipe distance 15cm with chain hoist, slowly down. Connecting pipe to the blue and submersible pump flange gasket between the good rubber gasket, bolts, nuts and spring washers will be connected to the pipe flange and submersible electric pump flange evenly forced tightening.
3) the submersible pump slightly lifted, remove the clamp at the upper end of the submersible pump, and use plastic tape or cable to connect cable card will fasten the hose, slowly under the hoop firmly resting on the wellhead.
4) with the same method, all the water pipes connected to the submersible pump, and human wells.
5) the submersible pump out cable access control switch, and then connected three-phase power supply.
没有评论:
发表评论